Boomerang Throttle Bolt Kits - For Carbs With Spacers

ALL NEW THROTTLES NOW COME WITH THIS KIT AS STANDARD!

These Bolt Kits are for Boomerang Throttles purchased before 20/05/2025

Issues with earlier models that you may face:

• The first range of throttles were designed for those that don't run spacers, once you run a 5-6.35mm spacer the WOT and Idle Screw can be a little short.
• Also All Previous Throttle were shipped with ONLY Pan head hardware, this kit contains HEX head hardware for use with spanners.  This helps with some tight installations.

The price of new throttles has been increased to cover the extra standard parts, so those early adopters are not out of packet compared to those who purchased later.

Contents

The following stainless parts are included:

• M4 x 35 x 0.7 Pan head screw for WOT/IDLE
• M4 x 40 x 0.7 Pan head screw for WOT/IDLE
• M4 x 16 x 0.7 HEX head Screw for Lever Clamp
• Two M4 x 8 x 0.7 Hex head screw for Sheath and Cable Clamp

Safety and Words of Wisdom

• It is YOUR responsibility to ensure the safe operation of this part and its legality on the roads of your country.  By building a custom bike you take on the responsibility for your work, respect that responsibility and show the next generation how to respect it so they continue the traditions!
• If you are not qualified to work on motorcycles please seen an approved professional to perform the work for you.
• I will not help you tune your carb, seriously! don't even call about that!
• I'm one bloke in a shed, in Australia, with a Wife, Dog, and 9-5 Job.  I'm not a corporation, I'm not rich, and I don't intend to become rich of the backs of you lot so my profit margins are LOW so that you can do cool shit.  Please remember this when dealing with me, lets all work together.

Thankyou to Fish at Alleyway Kustoms for the positive feedback that led to this change.